Wavlink AX1800 setup

Wavlink AX1800 Setup

How to use the Wavlink AX1800 setup. You can now bid your dead zones at home or at work a fond farewell thanks to the Wavlink AX1800 WN583AX1 WiFi repeater. It is a dual-band WiFi 6-mesh extender. It provides an 80 MHz bandwidth for increased efficiency and capacity. Following a successful Wavlink AX1800 setup, your current router’s range will be increased, allowing you to use the internet even in the farther-flung corners of your home or place of business.

Wavlink AX1800 Extender Setup-Manual Guide

  1. When the power LED on the Wavlink AX1800 extender is stable, plug it in.
  2. Connect your device to the Wi-Fi network of the extender.
  3. Enter “ap.setup” in the address bar of an open web browser.
  4. Enter the default qualifications, admin/admin, to log in.
  5. To customise the extender settings, follow the on-screen instructions.
  6. For better coverage, connect your devices to the extended Wi-Fi network.

Wavlink AX1800 WiFi Extender Setup-WPS Guide

  1. Activate the Wavlink AX1800.
  2. Position it close to the current modem/router.
  3. Just press the WPS button on your WN583AX1.
  4. Press the same button on your router now as well.
  5. as soon as the WPS light turns green.
  6. This indicates that your router and extender have successfully established a connection.
  7. The booster can now be unplugged and placed in an area with dead spots.

NOTE : If you need any help regarding your wavelink wifi range extender so get in touch with the technician or visit the official web site that is wavlink wifi extender setup

Wavlink AX1800 WiFi Range Extender Login

  1. Make a connection using the Wavlink AX1800 extender’s default wireless network.
  2. Enter “ap.setup” in the address bar of an open web browser.
  3. Enter the default qualifications, admin/admin, to log in.
  4. Open the settings interface on the extender.
  5. Change network settings as necessary.
  6. To improve coverage, reconnect your devices to the expanded Wi-Fi network.

How do I update the firmware on the Wavlink AX1800?

  1. Turn on your WN583AX1 first.
  2. Access any smart device.
  3. Check out “ap.setup.”
  4. After selecting Settings, select Firmware Upgrade.
  5. To complete the firmware upgrade process, follow the instructions displayed on the screen.
  6. The AX1800 should not be unplugged while the update is running.

Wavlink AX1800 Reset

  1. Turn on your Wavlink AX1800.
  2. Find the factory reset button inside a hole on your booster’s side panel.
  3. Press the factory reset button for seven to ten seconds with a hard pin.
  4. Your extender will automatically reboot and get ready for the first time once the LED begins to blink.
  5. Remember not to unplug your extender until the procedure is finished.

Leave a Reply

Your email address will not be published. Required fields are marked *